Page 2 / 5
Turn off the power at fuse or circuit box
Turn on the power at fuse or circuit box
Installation Steps
1. Unscrew the two set screws (D), remove the two rubber pads (E) and the mounting plate unit (A) from the backplate.
2. Attach the mounting plate unit (A) to the outlet box by using two mounting screws (B).
Note: Make sure that two set holes are lined up horizontally to make the fixture level.
3. Gently insert the glass panels into the top notches of fixture
,
then press the bottom
clips to secure the glass panels. (See Fig.1 and Fig.2)
4. Pull out the source wires from the outlet box. Make wire connections using wire
connectors (C) as follows:
• Connect the hot wire (usually black insulation) from the fixture to the black wire
from the power source.
• Connect the neutral wire (usually white insulation) from the fixture to the white
wire from the power source.
• Attach the fixture grounding wire (usually green with the insulation or bare wire)
to the mounting plate unit (A) with green grounding screw. Then, depending on
local code, connect it to the house grounding wire with the wire connector (C).
Carefully put all of the wires back into the outlet box.
5. Attach the backplate of the fixture to the mounting plate unit (A) by aligning holes,
secure the two set screws (D) and two rubber pads (E) from the side hole of the
backplate into the hole of the mounting plate unit (A).
Note: With silicone caulking compound, caulk completely around where the
backplate meets with the wall surface to prevent water from seeping into the
outlet box.
6. Install the bulb (not included). See relamping label at socket area or packaging for maximum wattage allowed.
Glass Panel
Fixture
Bottom Clip
Fig.1
The Position of Control Panel
Step 1: Rotate the sensor lens from left side to right side
to show the adjustable knobs and slide switch.
(See Fig.3)
Step 2: Adjust time
by knobs and choose the mode you want by
slide switch. (See Fig.4 and Fig A).
Step 3: Restore the sensor lens to original position.
(See Fig.5)
low level brightness and sensitivity
Sensor
Lens
Fig.3
View Fig.A
Fig.4
Sensor
Lens
Fig.5
“Time” Knob
“Sens” Knob
Slide Switch
“Low Level” Knob
Time
Low Level Sens
Fig.A
Test 3H 6H
0
210317
Glass Panel
Fixture
Top Notch
Fig.2
