Installation Steps
1. The fixture mounting bracket is pre-assembled on the light fixture.
Unscrew both the decorative cover and the fixture mounting screw
in order to remove the mounting bracket.
2. Install the mounting strap to the outlet box with the stamped word
“FRONT” facing away from the outlet box, using two mounting
screws that best fit the outlet box.
3. Pull out the source wires from the outlet box. Make wire connections
using wire nuts as follows:
---Connect the black wire from the fixture to the black wire from the
power source.
---Connect the white wire from the fixture to the white wire from the
power source.
---Connect the grounding wire from the fixture to the grounding wire
from the power source. (usually green / yellow insulation)
Carefully tuck the wires back into the outlet box.
4. Place mounting bracket against the outlet box, insert the mounting bracket screw through the mounting bracket hole,
thread mounting bracket screw into the center hole of the mounting strap. Tighten the mounting bracket screw securely.
▲ When mounting to a wall, the “UP” arrow must point upward. (See Fig. 1)
▲ When mounting to an eave, the “UP” arrow must point toward the building.
5. Attach the back plate of the light fixture to the mounting bracket, secure it with the fixture mounting screw.
6. With silicone caulking compound, caulk completely around where the
mounting bracket meets the wall surface.
CAUTION: Be sure to caulk completely where the mounting bracket meets the wall surface to prevent water
from seeping into the outlet box.
T0103 --- Page 2 / 5
Sensor
Mounting Strap (E)
Mounting Bracket
Outlet Box
Wire Nut (G)
Back Plate
Mounting Screw (A)
Light Head
sensor
1. Aim sensor head toward desired detection area, maintaining a
5° - 40° downward angle to allow moisture to drain.
Note: Make sure sensor head is positioned with control knob facing
towards the ground.
2. You can rotate the sensor head up and down to change the coverage
area. (See Fig. 2) Walk through the detection zone at the farthest
distance you wish to detect motion.
Note: Range set too high may increase false triggering.
(See Fig. 3 and Fig. 4 on Page 3)
Adjusting the Sensor Head:
Turn off the power at fuse or circuit box.
Turn on the power at the main fuse or circuit breaker box.
Fig. 2
Fixture Mounting Screw (F)
Mounting Bracket Screw (D)
Fig. 1
FRONT
140919
