Vaxcel T0062, Assembly And Installation Instructions

Page: 2 / 3

130606
1. Turn off the power at the main fuse or circuit breaker box before starting installation.
2. Loosen the wire nuts connected with the wires from photocell. (See Fig.2)
Note: Do not move the photocell to prevent water from seeping into the outlet box.
3. Take a white pigtail and black pigtail and make wire connections using wire nuts: (See Fig.3)
a. The black wire from the fixture to one end of the black pigtail.
b. The white wire from the fixture to one end of the white pigtail.
c. The other end of the black pigtail to the black wire from the power source.
d. The other end of the white pigtail to the white wire from the power source.
Put all wires back into the back plate of the fixture.
Photocell
White Wires From Photocell
Wire Nuts
Wires From Fixture
Wires From Fixture
Wires From
Main Power
Wire Nut
White Pigtail
Pigtail
Red Wires From Photocell
Black Wires From Photocell
Operation the Unit Without Photocell
Fig.2
Fig.3
3. Take a glass panel and gently slide the narrow side of the glass panel down into the metal frame
in place, secure it by pressing the clips from both top and bottom sides. (See Fig.1) Repeat with
other panels.
4. Secure the loop to the nipple of the fixture.
5. Pull out the outlet wires and the house grounding wire from the outlet box. Make wire connections
using the wire nuts:
---Connect the black (hot) wire from the fixture to the black (hot) wire from the power source.
---Connect the white (neutral) wire from the fixture to the white (neutral) wire from the power
source.
---Attach the fixture grounding wire to the mounting plate with the green grounding screw. Then
connect it to the house grounding wire with a wire nut.
Carefully put the wires back into the outlet box.
6. Attach fixture to the wall by aligning fixture mounting screws on mounting plate with holes on back
plate. Slide fixture mounting screws through holes, secure them with two rubber pad and ball nuts.
7. With silicone caulking compound, caulk completely around where the back plate meets with the
wall surface.
CAUTION: Be sure to caulk completely where the back plate meets the wall surface to
prevent water from seeping into the outlet box.
8. Install a bulb (not included). See relamping label at socket area or packaging for maximum
allowed wattage.
9. Turn on the power at the main fuse or circuit breaker box.