Page 4 of 6
ASSEMBLY INSTRUCTIONS (continued)
ASSEMBLY INSTRUCTIONS (continued)
Adjusting the Light Head:
1. Gently grasp the light heads and move them up or down, left or right to adjust the
light coverage area. (See Fig. 2)
2. Keep the light heads 30˚ below horizontal to avoid water damage and electrical
shock.
Sensitivity of Motion Sensor:
● You can adjust the sensitivity of the motion sensor by using the “MOTION SENSITIVITY” selector located at
the back of the sensor (See Fig. 3).
Note: Range set too high may increase false triggering.
● Adjust motion sensor sensitivity to achieve desired performance.
● Approximate range for each setting from 20ft to 40ft.
Function and Operation
Note: When power is first applied, the light will turn on. The sensor will take 30 seconds to warm up.
1. “ ” MODE( daytime and nighttime operation)
●
Turn the knob clockwise to“ ” position, the light turns on
after expiration of the warm-up period, It stays on when
motion is detected. When motion is no longer detected, it
remains on for the predetermined shut-off delay time you
set (5s~3min), and then turns off automatically.
2
. “ ”
MODE(nighttime operation only)
●
Turn the knob counter clockwise to“ ” position, the light
turns on after expiration of the warm-up period, it stays on
when motion is detected. When motion is no longer detected,
it remains on for the predetermined shut-off delay time you
set (5s~3min), and then turns off automatically.
● The light turns off automatically at dawn.
3. Manual Override MODE(nighttime operation only)
● To temporarily override the setting in “ ”
mode for
continuous brightness at night, turn the wall switch “OFF”
then turn it “ON” within 3 seconds. The light remains on all
night long. To shift back to “ ” mode, turn the wall switch
“OFF” then turn it “ON” within 3 seconds again.
●
The light turns off automatically at dawn.
Note: To make sure the above functions operate properly, always keep the wall switch in the “ON” position
(including the daytime).
Fig. 3
PC
SENSITIVITY
MOTION
SENSITIVITY
TIME
Mode
Manual
Override
Manual Override Operation Diagram
Turn wall switch OFF-ON
in 0.5~3 Seconds
Turn wall switch OFF-ON
in 0.5~3 Seconds
Fig. 4
ASSEMBLY INSTRUCTIONS (continued)
ASSEMBLY INSTRUCTIONS (continued)
ASSEMBLY INSTRUCTIONS (continued)
FUNCTION AND OPERATION (continued)
Fig. 2