vax.co.uk
5
Before you begin cleaning
Operating your pre-treatment wand
Pre-treating your carpet before washing will help to remove stubborn stains. Do not saturate your carpet.
Mix the solution with warm
water (max 40 C) and fill
tank with solution.
Remove clean water tank.
Tighten cap before
returning tank to unit.
Place the clean water tank
back on the carpet cleaner.
Attach the pre-treatment tube
to the water supply port.
Turn clockwise to secure.
Unwrap power cord,
plug unit in and turn
the on/off switch.
Using the wand and trigger,
apply the pre-treatment
solution to your carpets.
Spray evenly onto desired
areas and leave for 10-15
minutes before washing.
O
Pour required dose of pre
treatment solution (approx.
40ml per 1.0L of water.)
Do not saturate your carpet.
• Test for colourfastness – Wet a white absorbent cloth with the solution. In a small, hidden area of your carpet, gently rub the
surface with the dampened cloth. Wait ten minutes and check for colour removal or bleed with white paper towel or cloth. If your
carpet has more than one colour, check all colours.
• When cleaning an entire room, move furniture out of the area to be cleaned. If the furniture is too heavy to move, place aluminium
foil or wax paper under legs. This will prevent wood finishes from staining your carpet. Pin up furniture skirts and curtains.
IMPORTANT:
Carpets should be dry vacuumed thoroughly before washing.
IMPORTANT:
Only use Vax carpet cleaning solution. Using other solutions may cause excess foaming. Excessive foam will prevent
the machine from working effectively. Using other solutions will invalidate the guarantee.
