Vax VX62, Let'S Get Started, Page: 9 / 20

Getting started
Assembling your 2-in-1 vacuum cleaner
Line up the handle with
the main body and lower
into place.
Insert the screw into the
back of the handle. Using
a cross head screw driver
tighten until the handle is
secured into place.
Line up the handheld
nozzle with the back
of the main body. Push
the handheld onto the
main body until it clicks
into place.
PLEASE READ ‘LET’S TALK SAFETY’ AT THE BEGINNING BEFORE USE
Accessories & Consumables
Store the 2-in-1 Tool on
board the vacuum cleaner
by pushing the tool fi rmly
into the tool holder located
on the back of the handle.
Before you begin
CAUTION: Always switch off the vacuum cleaner before connecting or disconnecting the handheld/attachments or
removing and emptying the dirt container.
IMPORTANT:
The vacuum cleaner is equipped with a thermal cut-out. If for any reason the vacuum cleaner does
overheat the thermostat will automatically turn the vacuum cleaner off . If this happens, switch the vacuum cleaner off .
Remove and empty the dirt container. Also check the vacuum cleaner for blockages. Allow the vacuum cleaner to cool
for approximately 1 hour (if you have washed the fi lter please wait 24 hours for the fi lter to fully dry before putting
back into the machine). For best cleaning results, fi lters require cleaning every 4-6 uses or as needed depending
upon use. If the vacuum cleaner is blocked, switch off before removing the blockage.
Pre-motor fi lter Model No. VX62F
Plug the charger into the charging port, located on
the top of the handle of the handheld and plug
into the mains.
Once fully charged (5
hours) the LED indicator
on the handheld will
illuminate green.
When the vacuum needs
recharging the LED light
on the handheld will fl ash
red and the machine will
cut out.
Charging your 2-in-1 vacuum cleaner
NOTE: Initial charge is 5 hours, charging will be required before fi rst use. Failure to fully charge the battery before
fi rst use may result in poor battery performance. Charge time is 5 hours thereafter.
The vacuum can be charged with the handheld either attached to or detached from the main body.