Vax Service line
AU: 1300 361 505 / NZ: 0800 800 900
8
Maintenance
Cleaning the pre-motor filter
NOTE:
This is located underneath the dirt container bin.
1. Release the pre-motor filter cover by pulling on the tab.
2. Lift out the filter unit and separate the filter and case.
3. The pre-motor filter can be rinsed in warm water (max 40°C). Allow to air dry for 24 hours before replacing.
NOTE:
Do not use any detergents or boiling water to wash the filter. Vax recommends this filter should be checked and cleaned
periodically, depending on level of use.
4. Return the pre-motor filter and case to the vacuum cleaner and replace the pre-motor filter cover before restarting the
vacuum cleaner.
Cleaning the cyclone separator
1. Twist and pull the dirt container bin off the cyclonic separator. The dirt container bin may be wiped clean.
2. The separator should be cleaned with a soft brush and wiped with a damp cloth.
3. Leave the separator to dry completely before replacing. Allow 24 hrs to dry.
Cleaning the post-motor filter
NOTE:
This is located on the rear of the vacuum cleaner.
1. Release the post-motor filter cover by lifting the tab and remove the filter by pressing in the two catches.
2. The post-motor filter can be rinsed in warm water (max 40°C).
Allow to air dry for 24hours before replacing.
NOTE:
Do not use any detergents or boiling water to wash the filters. Vax recommends washing the filter every 9-12 months,
depending on level of use.
3. Replace the post-motor filter and cover before restarting the vacuum cleaner.
Replacement Filters
If lost or damaged replacement filters are available from your stockist or Vax direct.
Phone Vaxcare or visit www.vax.com.au for stockist listing.
Cleaning Blockages
1. Turn the vacuum cleaner off and unplug from the electrical outlet.
2. The flexible hose can be disconnected from the vacuum cleaner by turning the hose to the left and pulling away from the
machine. Remove any blockages found then reconnect the hose securely.
Storage
NOTE:
Always store the vacuum cleaner base down.
WARNING:
To reduce the risk of injury, the power cord must be disconnected before performing maintenance /
troubleshooting checks.
IMPORTANT:
the cyclone separator should not be submerged in water
IMPORTANT:
Always unplug the vacuum cleaner from the electrical outlet and
rewind the power cord as directed before storing.
Summary of Contents for VPPST1600
Page 11: ...11 www vax com au Notes ...
