background image

Vax Service line

AU: 1300 361 505 / NZ: 0800 800 900

3

General Safety Information

FOR HOUSE HOLD USE ONLY. 

When using the hard floor cleaner, basic safety precautions 
should always be observed, including the following: 

1. 

 Do not leave the hard floor cleaner unattended when 
plugged in. Unplug it from socket when not in use.

2. 

To prevent electric shock do not use outdoors.

3. 

 Not to be used as a toy. Children should be supervised 
to ensure that they do not play with the appliance.

4. 

 This appliance is not intended for use by persons 
(including children) with reduced physical, sensory 
or mental capabilities, or lack of experience and 
knowledge, unless they have been given supervision 
or instruction concerning the use of the appliance by 
a person responsible for their safety. 

5. 

Use only as described in this manual. 

6. 

 Do not use the cleaner if it has been dropped, 
damaged, left outdoors or dropped into water. Do not 
use the cleaner with a damaged cord or plug. If the 
supply cord is damaged, it must be replaced by the 
manufacturer or a recommended Service Agent to 
avoid hazard and invalidating the guarantee. 

7. 

 Do not pull or carry by cord/hose. Do not use the 
cord/hose as a handle, close a door on the cord/hose 
or pull cord/hose around sharp edges or corners. 
Do not run the carpet washer over the cord/hose. 
Keep the cord away from heated surfaces. 

8. 

Do not unplug by pulling on the cord. 

9. 

 Do not handle the plug or hard floor cleaner with 
wet hands. 

10.   Do not put any objects into openings or operate with 

openings blocked, keep them free of anything that 
may reduce airflow. 

11. 

 Keep hair, loose clothing, fingers and all parts of the 
body away from openings and moving parts. 

12.   Do not use the hard floor cleaner on any glowing, 

burning or smoking particles.

13.   Do not use without the solution tank and dirty water 

tank in place.

14.  Turn off all controls before unplugging.

15.   Do not use to pick up flammable or combustible 

liquids such as petrol, or use in areas where they may 
be present.

16.  Keep the unit on the floor.

17.   Do not attempt to remove blockages with sharp 

objects as they may cause damage.

18.   Store in doors put away after use to prevent 

tripping accidents.

19.   Using improper voltage may result in damage to the 

motor and possible injury to the user. The correct 
voltage is listed on the rating label.

20.   A hazard may occur if the cleaner runs over the power 

supply cord.

21.   To prevent dirty water from running into the motor, do 

not hold the appliance upside-down or lay on its side. 
Use appliance in normal cleaning position.

22.  Use extra care when cleaning on stairs.

23.  Do not carry appliance while motor is running.

24.   Use only SAA approved 10 amp extension cords. 

Non-approved cords may overheat. Care should 
be taken to arrange the cord so that the cord cannot 
be tripped over.

WARNING:

  Always switch off and unplug your 

machine from the electrical out let before filling 

and emptying the solution tank, emptying the dirty water 
tank, before assembling, opening, before connecting/
disconnecting the attachments, or carrying out 
maintenance or trouble shooting checks and storage.

NOTE:

  Hard floors should be dry vacuumed 

thoroughly before washing.

IMPORTANT:

  Cleaning filters maintains cleaning 

performance. Vax recommends that your filters 

should be checked and cleaned periodically. If your filters 
are washable make sure they are completely dry before 
inserting back into the machine. 

This machine is intended for house hold use only, 
and NOT for commercial or industrial use. 

PLEASE KEEP THESE INSTRUCTIONS FOR 
FURTHER USE.

Summary of Contents for VHFM700

















Reviews: