background image

4

5

2. Safety Information

FOR HOUSEHOLD USE ONLY

When using the vacuum cleaner, basic safety
precautions should always be observed, including
the following:

1.

Only use the vacuum cleaner indoors on dry
surfaces.

2.

Turn off the vacuum cleaner controls before
connecting or disconnecting from the mains
supply.

3.

Always unplug the vacuum cleaner before
connecting or disconnecting the vacuum hose
and accessories.

4.

Close attention is necessary when used by or
near children. Do not allow children to use as 
a toy.

5.

Use only as described in this manual. 
Use only the manufacturer’s recommended
attachments.

6.

Do not use the vacuum cleaner if it has been
dropped, damaged, left outdoors or dropped
into water. Do not use the vacuum cleaner with
a damaged cord or plug. If the supply cord or
plug is damaged, return the vacuum cleaner to
a Vax Authorised Service Agent or suitably
qualified person for examination, repair or
adjustment.

7.

Do not pull or carry by the cord. Do not use the
cord as a handle, close a door on the cord or
pull the cord around sharp edges or corners.
Do not run the vacuum cleaner over the cord.
Keep the cord away from heated surfaces.

8.

Do not handle the plug or vacuum cleaner with
wet hands. Do not use outdoors or on wet
surfaces.

9.

Do not put any objects into openings. Do not
use with any openings blocked and do not
restrict air flow. Keep all openings free of dust,
lint, hair or anything that may reduce airflow.

10. Keep hair, loose clothing, fingers and all parts

of the body away from openings and moving
parts.

11. Do not pick up hot coals, cigarette butts,

matches or any hot, smoking or burning
objects.

12. Do not pick up flammable or combustible

materials (lighter fluid, petrol, kerosene, etc) or
use in the presence of explosive liquids or
vapours.

13. Do not vacuum up harmful or toxic material

(chlorine bleach, ammonia, drain cleaner, etc).

14. Do not vacuum up hard or sharp objects such

as glass, nails, screws, coins, etc.

15. Do not use without the filters in place.

16. Take extra care when vacuuming on stairs.

17. Keep vacuuming area well lit.

18. Store the vacuum cleaner indoors in a cool, dry

area.

19. Turn off the on/off switch before unplugging the

vacuum cleaner.

20. Use only CE-approved 13 amp extension

cords. Non-approved extension cords may
overheat. Care should be taken to arrange the
cord so that the cord cannot be pulled or
tripped over.

WARNING:

Always switch off and unplug the

vacuum cleaner from the electrical outlet 
before assembling, opening or emptying the dirt
container, or before connecting/disconnecting the
attachments.

CAUTION:

The vacuum cleaner is a very powerful

unit. Before plugging the cord into the electrical
outlet, make sure the switch is in the ‘off’ position.
Hold the vacuum cleaner firmly when starting and
in use.

IMPORTANT:

If the inlet, hose or telescopic tube is

blocked, switch off the vacuum cleaner and remove
the blockage(s) before re-starting the vacuum
cleaner.

IMPORTANT:

Washing filters improved vacuum

performance. Make sure all the filters are
completely dry before inserting back into the
vacuum cleaner.

This vacuum cleaner is intended for household use
only and not for commercial or industrial use.

Motor Thermostat

IMPORTANT:

The motor is equipped with a

thermal cut-out. If for any reason, the vacuum
cleaner should over-heat, the thermostat will
automatically turn the unit off. Should this occur,
unplug the vacuum cleaner from the electrical
outlet and turn the unit off. Remove the dirt
container and empty. Clean the filters. Allow the
cleaner to cool for approximately one (1) hour. To
re-start, plug into an electrical outlet and switch
back on.

3. How to Assemble

IMPORTANT:

Always unplug the vacuum cleaner

from the electrical outlet before assembling or
removing the accessories.

1.

Insert the flexible hose into the inlet on the main
body of the vacuum cleaner. Push in until it
clicks into position (Fig.3/1).

2.

Push the telescopic extension tube on to the
end of the handle (Fig.3/2).

3.

The telescopic extension tube can be
lengthened or shortened by pushing the button
in and sliding the tube apart or together as
required (Fig.3/3).

4.

Fit the combination floor head by pushing onto
the extension tube (Fig.3/4).

4. How to Operate

Cord Release

Fully unwind the power cord. A yellow mark on the
power cord indicates the recommended cord
length. Do not exceed the cord length beyond the
red mark.

On/off Button

1.

Insert the power plug into the electrical outlet.
Make sure the vacuum cleaner is switched off.

2.

Press the on/off switch located on the top of
the vacuum cleaner, to switch on the vacuum
cleaner and press the button again to turn the
vacuum cleaner off.

Carpet Cleaning

For carpet and rug cleaning, press the rocker
switch on the combination floor head to raise the
brushes.

Hard Floor Cleaning

For hard floor cleaning, press the rocker switch on
the combination floor head to lower the brushes.

Cord Rewind

To rewind the power cord, press the cord rewind
button, located on the top of the vacuum cleaner,
and guide the power cord with one hand. This will
prevent the cord from whipping which could cause
damage or injury.

Variable Power

Located between the on/off and cord rewind
buttons there is a variable power dial. Slide this
clockwise and anti-clockwise to adjust the suction
power. The 5-stage indicator lights suggest the
suction power for common tasks.

Carry Handle

Use the carry handle located at the rear end of the
vacuum cleaner to move from room to room.

Hose Storage

For convenience there is a slot located on either
side of the vacuum cleaner where the floor tool and
hose can be parked for carrying and storage.

5. Accessories

1.

The accessories can be attached directly to the
handle by removing the telescopic tubes and
pushing in the desired accessory.

2.

The accessories can also be attached to the
telescopic extension tube for extra reach.
Remove the combination floor head and push
on the desired accessory.

Crevice tool:

for crevices, corners and cracks,

etc.

Dusting brush:

for delicate surfaces.

Upholstery tool:

for carpet, upholstery, stairs, etc.

TurboBrush:

for pet hair and larger carpeted

areas. (

NOTE:

not recommended for hard floors).

X-tend 

(Model: V-091X only): for bottom-to-top

stair cleaning. 

1.

The hose fits directly into the hose inlet on the
vacuum cleaner.

2.

The handle fits directly on to the telescopic
extension tube.

3.

To release the extra length hose, press the
release clips located on the handle.

Safety Information

How to Assemble / How to Operate / Accessories

Fig.3/1

Fig.3/2

Fig.3/3

Fig.3/4

V-091 U-G aw  21/10/05  10:56 am  Page 5

Reviews: