vax.co.uk
7
vax.co.uk
9
Looking After Your Machine
Replacing the belt
Cleaning the filter
To remove the belt cover,
use a phillips screwdriver
to remove the two screws.
Grasp the brush bar with
one hand, using the other
hand to keep tension on the
belt while removing by lifting
upwards.
Slide the belt off the motor
shaft and dispose.
Rinse the filter with warm
water. Allow it to dry fully
before replacing it in
your cleaner.
Replace new belt on to
spindles and secure the
belt cover.
Replace the belt cover
inserting the end furthest
from the brush first.
Then replace the front of the
belt cover before securing in
place with the two screws.
IMPORTANT:
Cleaning filters maintains cleaning performance. For best cleaning results filters require cleaning at least every
three months. If your filters are washable make sure that they are completely dry before inserting them back into the cleaner.
IMPORTANT:
The motor is equipped with a thermal cut-out. If for any reason the unit should overheat, the thermostat
will automatically turn the unit off. Should this occur, unplug the carpet washer from the electrical outlet and and turn off the switch.
Check the hose for blockages. Clean the filters. Allow the unit to cool for approximately one hour (if you have cleaned the filters
you will need to wait twenty four hours for the filters to dry before putting them back in the machine.) To re-start the machine,
plug it into an electrical outlet and switch it back on.
WARNING:
To reduce the risk of electric shock, turn the machine off and unplug from electrical socket before performing
maintenance/troubleshooting checks.
WARNING:
Always switch off and unplug the carpet washer from the electrical outlet before assembling,
filling and emptying the clean water tank, emptying the dirty water tank, or before connecting/disconnecting
the attachments.