27
7
8
Emptying the dirty
water tank
Return dirty water tank to the base
of the cleaner by tipping the nozzle
down into the basin and dropping it
into place.
Lift the front of the cleaner base off
the carpeting with one hand. Line
up the black tabs with the grooves
of the front nozzle. Lift the front
nozzle upwards towards the cleaner
and press under the latch until it
locks into place.
26
Post-treating your carpets
with the carpet wand and
post-treatment solution
1
N.B
The carpet treatment wand will
need priming before using to allow
the correct solution to run through.
Holding over the sink, depress the
trigger for approximately 20
seconds. The wand will then to
ready for post-treatment.
Remove the clean water tank by
pressing the clean water tank
release and pulling the tank by the
handle. Put to one side to fill later.
2
3
While the clean water tank is
removed, loosen the solution tank
by gently pushing out the solution
plug from the plug opening.
Note
: The solution tank can be
filled while it is attached to the
cleaner but you should use care
when refilling.
Remove the solution tank by pulling
up and out.
Note
: After spraying rinse the
machine and carpet treatment
wand with clean water. Wash the
carpet as described in this guide,
using VAX AAA carpet cleaner.
V027(Y) User Guide 5/10/06 11:47 am Page 13