3. Use & Function
Assembling the Carpet Washer
IMPORTANT
: Always unplug the carpet washer from
the electrical outlet before assembling or removing the
accessories.
1. Stand the base in an upright position. Push the
mid-section on to the base by aligning the tabs on
the backside of the base (Fig.3/1).
NOTE
: Make sure the power cord is out of the way
to avoid pinching.
2. Insert three (3) nuts into the recesses at the back
of base. While holding the nuts in place insert the
screws through the front of the mid-section and
tighten (Fig.3/2).
NOTE
: Do not trap the cable when assembling the
carpet washer.
3. Slide the handle down on to the unit. Place screw
into the recess at the back and tighten (Fig.3/3).
Fig.3/3
Fig.3/2
Fig.3/1
4. Place the clean water tank into the cleaner until it
clicks into place (Fig.3/4).
Cord Storage
Wrap cord around upper and lower cord wraps
(Fig.3/5). Clip plug to cord to secure for storage.
4. Preparing the Carpet
IMPORTANT:
The carpet washer is not a dry vacuum
cleaner.
1.
Vacuum carpet thoroughly. Use a vacuum
cleaner with a revolving brushbar for best
results.
2.
Remove as much furniture from the room as
possible. If unable to remove the furniture, place
plastic or foil under and around the legs until the
carpet has dried completely.
HELPFUL HINTS FOR CLEANING CARPET:
1.
Only use Vax AAA Carpet Cleaner with this
carpet washer.
2.
Do not oversaturate carpet with cleaning solution
while using the carpet washer.
3.
For heavily soiled areas, additional applications
may be necessary.
4.
Allow plenty of time to dry carpet thoroughly.
5.
Wipe cleaning solution from woodwork and
wood to prevent any damage.
6.
Try not to walk on carpet until it is completely dry.
7.
After carpet is thoroughly dry, vacuum the carpet
using a vacuum cleaner with a revolving brushbar.
Fig.3/5
Fig.3/4
Use & Function/Preparing the Carpet
4
Vax V-022(Q).qxd 23/8/06 11:47 Page 4