Vax Impact 502, Let'S Get Started

Page: 7 / 20

Getting to know your machine Getting started
Assembling your vacuum cleaner
Lift handle up and click
into place.
Dusting Brush into dusting
brush holder with brushes
facing outwards.
Line up latch on accessory hose,
push until clicks into place.
Line up TurboTool brushes into
TurboTool holder, push into place
until it clicks (some models only).
Push accessory hose into
hose to machine connector.
Push extension tube and
crevice onto holder.
Before you begin cleaning
WARNING: Always switch off the vacuum cleaner before connecting or disconnecting the hose/attachments
or removing and emptying the dirt container
IMPORTANT: The vacuum cleaner is equipped with a thermal cut-out. If for any reason the vacuum cleaner does
overheat the thermostat will automatically turn the vacuum cleaner off. If this happens switch the vacuum cleaner off
and unplug from electrical socket. Remove and empty the dirt container also check the vacuum cleaner for blockages.
Allow the vacuum cleaner to cool for approximately 1 hour (if you have cleaned the filters please wait 24 hours for the
filters to fully dry before putting back into the machine).
Filters require cleaning at least every 3-6 months. If the vacuum cleaner is blocked, switch off and unplug before
removing the blockage.
When the vacuum cleaner is stood in the upright position, or when using the hose and tools the brush bar height adjuster
must be set to the highest setting.
PLEASE READ ‘LET’S TALK SAFETY’ AT THE BEGINNING BEFORE USE