2. Parts Overview
1. Carry handle
2. Hose inlet
3. Auto cord rewind
4. On/off button
5. Variable power
6. Post-motor filter
7. Dirt container release button
8. Dirt container handle
9. Dirt container
10. Central filter
11. Plug
12. Wheel
13. Parking slot
Accesories
14. 2-in1 tool
15. Crevice tool
16. Combination floor tool
17. Flexible Hose
18. Telescopic Tube
3
Fig.2/1
7. Filters:
Removal & Replacement
IMPORTANT:
Always unplug the vacuum
cleaner from the electrical outlet before removing
the dirt container.
Cleaning the Central HEPA Filter
1. Remove the dirt container as directed.
2. Remove the gauze shroud from over the
HEPA filter.
3. Rotate the central filter and pull away from
the dirt container.
4. Gently tap the filter against the side of a
rubbish bin to remove excess dirt.
5. The central HEPA filter and shroud can be
washed in warm water (max 40
0
C). Allow to
air dry for 24 hours before replacing.
NOTE:
Do NOT use any detergents or boiling
water to wash the filter. Vax recommends
washing the filter every time you empty the dust
container.
6. Return the central filter to the dirt container
and twist until the filter is secure.
7. Fit the gauze filter shroud over the central
HEPA filter and close the dust bin lid.
8. Return the dirt container to the vacuum
cleaner.
Post-motor Filter
NOTE:
This is located on the right side of the
vacuum cleaner.
1. Release the post-motor filter cover by
pressing in the catch at the top of the cover.
2. Remove the filter by sliding it to the left and
pulling it out.
3. The post motor filter can be rinsed in warm
water (max 40
0
C). Allow to air dry for 24
hours before replacing.
NOTE:
Do NOT use any detergents or boiling
water to wash the filter. Vax recommends rinsing
the filter every 3-6 months.
4. Replace the post-motor filter and cover
before restarting the vacuum cleaner.
IMPORTANT:
Do NOT use the vacuum cleaner
without ALL of the filters in place.
Replacement Filters
Replacement filters are available from your Vax
stockist or Vax direct. Phone Vaxcare or visit:
www.vax.com.au
8. Cleaning Blockages
WARNING:
To reduce the risk of injury, the power
cord must be disconnected before performing
maintenance/troubleshooting checks.
1. Turn the vacuum cleaner off and unplug from
the electrical outlet.
2. The flexible hose can be disconnected
from the vacuum cleaner by pushing in the
buttons on the hose and pulling away from
the machine. Remove any blockages found
then reconnect the hose securely.
9. Storage
IMPORTANT:
Always unplug the vacuum
cleaner from the electrical outlet and rewind the
power cord as directed before storing.
NOTE:
Always store the vacuum cleaner base
down.
6
