Taking care of your machine
Cleaning the pre-motor filter
Remove dirt container
by pushing down the dirt
container release button and
lifting the dirt container.
Lift the dirt bin lid release clip,
in a hinge like manner lift dirt
bin lid.
Tap the pre-motor filter against
a bin to remove any dirt/debris.
TA
P
MAX
40˚C
!
MAX
40˚C
24hr
Lift the pre-motor filter and
remove from the dirt container.
Hold dirt container over a bin.
Press the dirt release clip at
the bottom of the container,
the dirt release door will open
allowing dirt/debris to fall out.
Emptying and cleaning the dirt container
Taking care of your machine
IMPORTANT:
Always switch off and unplug the vacuum cleaner from the electrical socket before assembling,
opening or emptying the dirt container, or before connecting/disconnecting the attachments.
Pre-motor filter should be tapped over a bin every 4-6 uses to remove dirt and debris. Do not use your vacuum
cleaner without all of the filters in place.
The motor is equipped with a thermal cut-out. If for any reason the unit should overheat, the thermostat will
automatically turn the unit off.
Rinse the pre-motor filter under
water (Max 40°C).
Leave to dry for 24 hours or until fully
dry before placing back in the machine.
TIP
Don’t over fill the
dirt container to
avoid blocking the
air flow through the
vacuum cleaner.