Using your machine
TIP
Carpets should be dry vacuumed
thoroughly before washing.
Operating your carpet washer
Remove the clean water tank.
Unscrew the clean water
tank cap from the top of
the clean water tank.
Pour required dose of carpet
cleaning solution (approx.
40ml per 1.0L of water) into
clean water tank. NOTE:
Measuring jug is not included.
40C
Max
Tighten cap before
returning tank to unit.
Unwrap power cord
and plug unit in.
Mix solution with warm
water (40°C Max). Fill
the clean water tank with
solution mix.
Turn the machine on.
Recline the machine.
Press trigger to
release solution.
For best results apply
solution on the forward
stroke and release the
trigger to recover solution
on the backward stroke.
Your dirty water tank is fitted with a float. When the dirty water tank is full or the floorhead is not in contact with the
carpet the float will shut off the suction at the floor nozzle. You will be able to hear if this has happened as the motor
noise on the unit will increase. Once the float is activated, empty the dirty water tank if full. If the dirty water tank is not
full then turn off your machine at the power switch and wait for the float to settle.
NOTE: If the solution/clean
water doesn’t dispense, the
clean water tank valve may
be stuck. Hold the clean
water tank over the sink and
press the valve underneath
to release.
