www.vax.co.uk
4
assembly/ operation
3. Assembly
Putting your cleaner together
Stand the base in the upright position. Assemble the mid
section onto the base, taking care not to trap internal
mains wire (Fig 3/1).
Insert the three nuts into the recesses located on the left
and right sides of the base and into the recess located in
the middle of the back of the base.
While holding the nuts in place insert screws through the
front of the mid section and tighten (Fig 3/2).
NOTE: Phillips screwdriver required
Slide the upper handle down onto the unit. Insert nut into
the recess in the back of the upper handle. While holding
the nut in place insert the screw through the front of the
upper handle and tighten.
Run the mains wire above the upper cord hook and
secure with the cord clip (Fig 3/3).
4. Operation
IMPORTANT: Turn off when emptying and filling
the reservoir.
Grasp the solution reservoir under the handle and press
the handle release lever upward (Fig 4/1).
Tilt the solution reservoir away from the cleaner and
remove (Fig 4/2).
Unscrew the filler/ measure cap from the rear of the
solution reservoir (Fig 4/3).
Fill the bottle cap or measure cap 4 times with Vax Ultra
Solution and pour into the reservoir (Fig 4/4).
Fig.3/1
Fig.4/1
Fig.4/2
Fig.3/2
Fig.4/3
Fig.4/5
Fig.4/6
Fig.3/3
!
V-024U User Guide v2.qxd:V-024U User Guide
12/3/08 08:47 Page 4
All manuals and user guides at all-guides.com
