Emptying and cleaning the dirt container
Using your machine
Taking care of your machine
Press dirt container release
button and lift to remove.
Twist the shroud and pull
to remove.
Hold dirt container over a bin
and pull the dirt release clip on
the bottom of the dirt container,
allowing dirt/debris to fall out.
Tap the shroud over a bin to
remove any dirt/debris.
Rinse the shroud under water
(Max 40°C) Leave to dry for 24
hours or until fully dry before
placing back in the machine.
IMPORTANT
: Unplug and switch off vacuum cleaner before performing maintenance or troubleshooting checks.
TIP
Don’t over fill the dirt container
to avoid blocking the air flow
through the vacuum cleaner.
MAX
40˚C
!
MAX
40˚C
TIP
Brushes on the floor head should
be visible when using on hard floors.
Unwind the power cord.
Do not pull further than the
yellow marker.
Plug into mains and push
the on/off button to turn
your machine on
IMPORTANT: The base of the vacuum cleaner should always be positioned flat on the floor when starting and in use.
The dirt container should be locked into place before lifting the vacuum cleaner by the carry handle.
CAUTION
: When unwinding the power cord do not pull further than the yellow marker.
For use on carpets, click
rocker switch forward.
For use on hard floors click
rocker switch back.
Slide vent cover on hose grip open
to reduce suction if required.
Raise brushes for carpets.
Lower brushes for
hard floors.
Choose an accessory.
Using accessories
Using your vacuum cleaner
Attach accessory to hose
end or extension tube.
If required use tool connector.
C86-AD/ID_Action_402_EcoSeries_UG_[J2543]_Amnd_02.07.14.indd 8-9
02/07/2014 12:40
