Using your machine
Before you begin cleaning
• Always switch off and unplug the vacuum cleaner before connecting or disconnecting the hose/attachments, or removing
and emptying the dirt container
• The vacuum cleaner is equipped with a thermal cut-out. If for any reason the vacuum cleaner does overheat the thermostat
will automatically turn the vacuum cleaner off. If this happens, switch the vacuum cleaner off and unplug from electrical
socket. Remove and empty the dirt container also check the vacuum cleaner for blockages. Allow the vacuum cleaner to
cool for approximately 1 hour (if you have cleaned the filters please wait 24 hours for the filters to fully dry before putting
back into the vacuum)
• Pre motor filters require cleaning at least every 3 months
• If the vacuum cleaner is blocked, switch off and unplug before removing the blockage
• When using the accessories always make sure the brushbar is switched to the off position
IMPORTANT:
When the vacuum cleaner is stood in the upright position or when using on stairs and the hose/tools,
the brushbar height adjust dial must be set to hard floor
Taking care of your machine
Telescopic extension tube
Remove hose end from
the floorhead.
Remove telescopic
extension tube.
Choose an accessory
Attach accessory to
hose end.
3-in-1 tool converts into:
a = Crevice tool
b = Upholstery tool
c = Dusting brush
a
b
c
Attach accessory to
telescopic extension tube.
Attaching the hose
IMPORTANT:
Hold unit while
using hose
or telescopic
extension tube.
Attach hose to telescopic
extension tube.
!
!
!
!
Using accessories
NOTE:
The crevice tool, dusting brush and upholstery tool can all be attached to the telescopic tube or directly to the hose.
Emptying and cleaning the dirt container
Cleaning the HEPA pre-motor filter
Press the dirt container
release button and pull to
remove the dirt container.
Turn the dirt container lid
anti-clockwise…
Tap the filter over a bin to
release any dirt.
Hold dirt container over
a bin and press the dirt
container release button to
open allowing dirt to fall out.
…and lift to remove.
Wash the filter under
running water (40°C max)
Grasp tab on filter and pull
to remove.
Leave to fully dry for at
least 24 hours before
putting back into the
vacuum cleaner.
40°C max
tap
!
!
!
!
24hr
MAX
40˚C
!
MAX
40˚C
