Vehicle care
211
Bulb replacement
Before replacing a bulb, ensure that
all exterior and interior lights and the
ignition are switched off. All doors
have to be closed.
Only hold a new bulb at the base. Do
not touch the bulb glass with bare
hands.
Use only the same bulb type for
replacement.
Replace headlight bulbs from within
the engine compartment.
Bulb check
After a bulb replacement switch on
the ignition, operate and check the
lights.
LED headlights
Headlights for low and high beam,
sidelights, daytime running lights and
turn lights are designed as LEDs and
cannot be changed.
Have lights repaired by a workshop in
case of failure.
Front fog lights
Front fog lights are designed as LEDs
and cannot be changed.
Have lights repaired by a workshop in
case of failure.
Tail lights
Tail lights, daytime running lights and
3rd-brake light are designed as LEDs.
In case of failure, have LEDs replaced
by a workshop.
Light assembly in the body
1. Open the tailgate then unclip the
access cover on the relevant side.
2. Slacken the light fixing nut using a
box spanner or socket.
To avoid losing the nut if it drops
into the wing trim, first place a
cloth below it.
3. Manually unscrew and remove
the light fixing nut.
4. Disengage the retaining clip,
while pushing the light out slightly.
Summary of Contents for Grandland
