Vauni Cupola, Manual

Page: 14 / 36

14 |
Vauni Cupola © Copyright 2015 Vauni AB - All rights reserved
ENG
The coating is removed with the following steps:
• If the fireplace has been used, it must be allowed to cool until the burner has reached room
temperature.
• Remove the regulator lid by lifting it straight up.
• Scrape off any coating around or inside the burner tray, using a rubber or plastic scraper. Take
special care around the burner matrix, and see that no particles fall down into the combustion
chamber or block the holes in the burner matrix.
• Remove the scraped-off coating by using a vacuum cleaner.
• Clean the area around the burner tray’s opening with a moist rag. If it is very dirty, a mild
detergent can be used sparsely. In this case, be very careful that the liquid does not run down
into the burner matrix or make contact with the surrounding liner.
• Scrape off any coating from the regulator lid, then clean it off with a moistened rag. If it is very
dirty, a mild detergent can be used sparsely.
• Place the regulator lid by lowering the two guide pins into the respective grooves. When
correctly placed, the regulator lid should lie closely against the burner’s surface and slide
easily when the regulator rod (which grips in the holes provided in the regulator lid) moves it
to its respective stop.
6.3 Liner parts
The metal liner require some carefulness in order to avoid discolouring. This applies especially
to spilled fuel, since denatured alcohol is a very strong solvent. To avoid discolouring, therefore,
any spilled fuel must immediately be wiped off with a dry rag.
Continuous cleaning of the liner should be done only with a dry rag or similar material.
7 FAULT FINDING
The fireplace cannot be lit
Possible causes:
• No fuel is in the burner module.
• The fuel level is too low.
• The burner’s safety system makes it hard to start.
• The fuel being used is incorrect, or has been diluted by excess cleaning liquid or the like.
• The regulator lid is not fully open.
Measures:
• Add fuel.
• Start the burner according to the instruction in Section 4.1 point 4.
• Change the fuel. See Section 4.2.1 for recommendations.