03 Vaultek
®
Warnings
To prevent damage to your Vaultek
®
unit or injury to yourself or to others, read the following safety precautions
before using this unit.
DO NOT
PLACE OR STORE THE BACKUP KEYS INSIDE THE SAFE AT ANY TIME. IF THE BATTERY FAILS, YOU WILL BE
UNABLE TO OPEN THE SAFE.
DO NOT
expose to extreme heat or cold. Battery power may be affected.
DO NOT
store loaded guns in this unit. Firearms are serious in nature and must be handled with respect. Store
responsibly.
DO NOT
get fingerprint sensor wet.
ALWAYS
check to make sure door has latched when closing; lid requires a firm press and locks automatically.
Check page 17 for Nano Key 2.0 warnings.
DISCLAIMERS:
NEITHER SELLER NOR MANUFACTURER SHALL BE LIABLE FOR UNAUTHORIZED ACCESS, ANY INJURY, LOSS OR
DAMAGE TO PERSONAL PROPERTY DIRECT OR CONSEQUENTIAL, ARISING OUT OF THE USE OF, OR THE INABILITY
TO USE THE VAULTEK
®
SAFE.
THE USER SHALL DETERMINE THE SUITABILITY OF THE VAULTEK
®
SAFE BEFORE THE INTENDED USE AND USER
ASSUMES ALL RISK AND LIABILITY WHATSOEVER IN CONNECTION THEREWITH. VAULTEK
®
SAFES ARE NOT
INTENDED TO PROTECT AGAINST ENVIRONMENTAL HAZARDS INCLUDING FIRE AND WATER.
Be sure and follow all local and state firearm laws.
DO NOT
operate a firearm without proper training and experience.
The Bluetooth
®
word mark and logos are registered trademarks owned by the Bluetooth SIG, Inc. and any use of
such marks by Vaultek Safe, Inc. is under license.
04 Vaultek
®
light up, replace the battery cover. You are now ready to program your safe.
Tip!
After installing the battery, use the charging kit provided to charge the unit 100%.
IMPORTANT!
Your Vaultek
®
safe will automatically lock when you fully close the lid.
Tip!
Register your safe online. This is important in the event you lose your keys. See page 08.
Battery:
Installation
Your safe uses a 3.7V 18650 rechargeable lithium-ion with a flat top.
A minimum 2000 mAh capacity is required, however 2200 mAh or
higher can be used to increase operation time.
To get started, insert one of your backup keys into the keyhole at
the front of the safe (see Figure A). Push key in and rotate the key
clockwise until you open the safe.
Remove the interior padding. Locate the battery compartment door
on the inside of the safe directly behind the '1' key on the keypad
(see Figure B).
Remove the battery cover by pressing down on the tab near the top
of the cover.
Tip!
Before inserting the battery
make sure to place the pull string
over the battery before closing the door for easy removal.
Insert the battery (included in accessory box) into the battery
compartment. Note that your Vaultek
®
safe automatically detects
the polarity of the battery and can be installed in either direction.
When the battery is inserted you will hear a short welcome tone and
the keypad will light up. Once you hear the tone and see the keypad
A
B
