4
Introduction
Quick Start
Components
The Vehicle Battery
The Transmitter
Transmitter and Receiver Binding
Control Test
Before Running Your Vehicle
Run Time
Tuning, Adjusting & Maintaining Your Vehicle
Dynamite 70A Waterproof Sensorless Brushless ESC
Dynamite Fuze 540 4-Pole 3300Kv Sensorless Brushless
Motor
Troubleshooting Guide
Limited Warranty
FCC statement
Compliance Information for the European Union
Fasteners
Replacement parts/Exploded Views
Optional Parts
4
4
5
7
9
9
10
10
11
11
13
14
15
17
18
18
70
71
91
INTRODUCTION
Thank you for purchasing the Vaterra™
1/8-Scale Glamis Uno™ Single Seat
RTR Buggy. This guide contains the
basic instructions for operating your
new Glamis Uno Single Seat Buggy.
It is critical that you read all of the
instructions in order to operate your
model correctly and avoid unnecessary
damage.
TABLE OF CONTENTS
/ / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / /
QUICK START
/ / / / / / / / / / / / / / / / / / / / / /
Please read the entire manual to gain a full understanding
of the Glamis Uno vehicle, fine-tuning the setup and
performing maintenance..
1. Read the safety precautions found in this manual.
2. Charge the battery. Refer to the included charging
warnings and instructions for battery charging
information.
3. Install the AA batteries in the transmitter.
Only use alkaline or rechargeable batteries.
4. Install the fully charged battery in the vehicle.
5. Power ON the transmitter and then the vehicle. Always
power the transmitter ON before the vehicle and power
it OFF after the vehicle has been powered OFF.
6. Check the steering and throttle control directions.
Verify that the servos are moving in the correct
direction.
7. Drive your vehicle.
8. Perform any necessary maintenance.
