55
6.3
Care and Cleaning
In order to prevent infection, wipe the front plate of the sensor unit with ethanol or
glutaraldehyde solution to disinfect it each time a different patient uses the instrument. If you
plan to use a disinfectant other than those specified above, or you are mixing another
disinfectant with ethanol, please consult a specialist because it may damage the plate.
To clean the EzSensor Classic, the following solutions are listed below. Please observe the
precautions noted.
●
Mild soap and water
●
Isopropyl alcohol (70%)
●
Most alcohol and ammonia based cleaners
●
Mild, non-abrasive cleaners
Do not soak or immerse any part of the Product, and be sure to dry it completely after cleaning.
Clean the surface of the Product by moistening it with a soft cotton swab dipped in one of the
cleaning solutions listed above. Gently wipe the surface end-to-end in straight lines, without
applying any pressure. Make sure the liquid does not penetrate the Product through the USB
cable or the sensor cable connectors.
After cleaning the surface of the EzSensor Classic, use a clean lint-free cloth to dry the
Product, as required, until the surface is clean.
※
Clean the silicone cover using the same method.
※
Do not use the following cleaning materials.
●
Hard brushes or scrapers of any kind
●
Strong acids or alkaloids
6.4
Precautions
●
Do not soak the sensor in water or alcohol.
●
Authorized service personnel can repair calibration issues.
●
Service personnel cannot handle problems that are not mentioned in this manual.
Please request repairs to the manufacturer through a VATECH dealer.
●
Equipment and accessories are to be disposed safely at the end of the Product life
cycle. National regulation must be observed.
