Vatech A9 (PHT-30CSS)
Technical manual
VDH-TeM-098
114 / 214
COPYRIGHT© 2020 VATECH
.
ALL RIGHTS RESERVED
3.
PANO Sensor Calibration
To optimize PANO image quality in the equipment, the operator should perform the Sensor setting &
calibration operation according to the following procedures.
Regular Sensor Calibration check-up is recommended to perform for image optimization against
temperature and humidity variation.
3.1. PANO Sensor Calibration Standard
•
PANO Sensor Dark Calibration Standard Value
-
Dark data file median value:
700 ~ 2300
•
PANO Sensor Bright Calibration Standard Value
※
Bright standard value: 5 points with Cu 1 mm filter
Bright
Min
Max
Median value
Cal Point 1
50
80
Cal Point 2
80
200
Cal Point 3
200
400
Cal Point 4
400
600
Cal Point 5
600 ~
From the achieved PANO Sensor Bright Calibration data file, the 1 Point
Bright Data file and 5 Point Bright data file should meet the standard
value. Other results from different points Bright Datafile can be varied by
characteristics of each sensor.
3.2. Before PANO sensor calibration
1. Remove the Normal Chin Block from the equipment.
2. Disassemble the Tube case (Refer to
Chapter 1. Hardware Part Service Guide
).
3. Rename the CAL folder (
C:\VCaptureSW\Acquisition\PANO\WidePANO\CAL
) name for backup.
