Using the Grid for Aligning Artwork
1
(
Graphics are for reference only and do not reflect actual Fixture Pallet Jig / Pin Board Com-
Fig 1
1) Place one carrier sheet onto the registration pins.
2) Choose the positive covering the largest area and
position over the carrier sheet.
3) Using the grid underlay for alignment.
4) Tape the positive to the carrier sheet with transpar-
ent tape. Tape must be outside of image area.
For Multicolor Printing
5) Leave the first carrier sheet and positive attached
to the registration pins.
6) Use a new carrier sheet, repeat steps 1-4 for the
second positive.
7) Remove the second carrier sheet and positive and
repeat steps 1-4 for each remaining positive. Leav-
ing the first carrier sheet and positive attached for
aligning all remaining positives.
8) Refer to step 2 for securing carrier sheet / positive
to screens. (Fig 2)
Tape
Positive
Carrier Sheet
Registration
Pins
Pallet Spacer Installation
14” Side Stop, 2- 5/16” (5.9cm) wide
15” Side stop, 1-13/16” (4.6cm) wide
16” Side Stop, 1- 5/16” (3.3cm) wide
17” Side Stop, 0-13/16” (2.1cm) wide
(3x) 1/16” spacers for fine width adjustment
1a) Vastex Pallets will require (1) 1/16” spacer to be used with appropriate Side Stop.
Pallet jig will accommodate a max of
1/4”
wider pallet than selected spacer.
(0) 1/16” spacer for
14-1/4”, 15-1/4”, 16-1/4”,
and
17-1/4”
actual width pallets.
(1) 1/16” spacer for
14-1/8”, 15-1/8”, 16-1/8”,
and
17-1/8”
actual width pallets
(VASTEX PALLETS)
(2) 1/16” spacers for
14”,
15”,
16”,
and
17”
actual width pallets.
(3) 1/16” spacers for
13-7/8”, 14-7/8”, 15-7/8”,
and
16-7/8”
actual width pallets.
1) Install Pallet Side Stop and Spacer. Choose
appropriate version for desired pallet width.
1/16” thick spacers supplied for fine width
adjustments. Check pallet center via center
cutouts
-Install Side stop and Spacer with (2) 10-32 Bolts
and Serrated nuts. Tighten well with 3/8” wrench.
Serrated
Nut
10-32
Bolt
Side
Stop
Pallet
Spacer
Pg2
