2)
Slide the square post, with the center hole at
the bottom and the (2) 5/16” bolts/floating nuts
at the top, into the square hole created by the
legs. Insert the 1/4-20 x 2 1/4” lg. hex head bolt
through legs and square post and fasten with
1/4” serrated lock nut. Tighten with a 7/16”
wrench. Evenly tighten all hardware in the as-
sembly. (Do not over tighten.)
3)
Turn the assembly over and install four level-
ers or (optional) casters, one at the end of each
leg with (4) 3/8” nuts and washers. Tighten us-
ing 9/16” wrench.
4)
Loosen slightly both 5/16” bolts, only enough
for the round post to slide past. Install round
post into square post. Slide the post down until
the end can be seen through the site window.
Tighten both 5/16” bolts to secure the round
post.
Do not over tighten bolts.
5)
Thread the knob into the lock collar and in-
stall the lock collar onto the post. Position the
lock collar 6" (15 cm) down from the top of the
post and tighten knob fully.
6)
Unpack the heater head assembly and uncoil
the line cord.
Be careful not to damage the heater surface!
7)
Attach 3 handles, one to each side of the heat-
er head with (12) #8 x 3/8” sheet metal screws
using 1/4” wrench.
8)
Carefully slide the heater head over the post
to rest onto the vertical adjustment locking
collar.
1)
Position the legs as shown below and bolt
together with 1/4” bolts and serrated lock nuts.
Do not fully tighten at this time.
Tools Required:
1/4” Wrench or nut driver
7/16”, 1/2” & 9/16” Wrench
Adjustable Wrench
Square Post
Cross Bolt 1/4” x 2-1/4” lg.
& lock nut
Flash Head
Handles
Round Post
Vert. Adjustment
Locking Collar
Square Post
Site Window
(see enlarged view)
Levelers or
Optional Casters
5/16” Bolts &
Floating Nuts
Spec. Tag
!
Assembly Instructions
Site Window
(Enlarged View)
Square Post
Round Post
4