VASTEX E-200 series, Assembly And Operation Instructions Manual

Page: 4 / 12

Doc. # 01-04-025H
Assembly
Getting started:
Your Exposing Unit has been fully assembled and tested in our factory. Both lid lifting
cylinders have been removed from their upper mounting stud and secured to the side of the
cabinet. Be careful not to damage the rubber vacuum blanket when removing the Exposing
Unit from it's crating.
It is best to keep the lid locked closed when lifting the exposing unit. Carefully remove the
unit from its crate and place it on a suitable surface. It is important that the surface be flat, an
uneven surface can put stress on the glass causing it to crack.
Install Lid Lifting Cylinders
Remove the acorn nut from the upper cylinder mounting studs located on both sides
of the lid. Unlock and carefully lift lid far enough to slide lifting cylinders onto studs.
Replace acorn nuts onto stud.
Snug only with a 5/8” wrench. Do not over tighten!
Control Panel
Power Cord
Equipment Spec Tag
Lid Limit Switch
Vacuum Exhaust
Vacuum Pump
(behind cover)
(2) Lid Lifting Cylinders
Rubber Vacuum Blanket
Lid Locking Handle (2)
Maximum screen
indicator, front corners
DC power supply,
LED lights, (inside)
LED light strip, (3)
Rear screen stops, right
stop vacuum intake
Lid
E200-2331 shown
E200-2128 components may be located elsewhere
Pg.4