Doc. # 01-04-021E
5)
Install Lid Lifting Cylinders
Remove the acorn nut from the upper
cylinder mounting studs located on both
sides of the lid. Unlock and carefully lift lid far
enough to slide lifting cylinders onto studs.
Replace acorn nuts onto stud. Snug only with
a 5/8” wrench. Do not over tighten!
1)
Install Legs on Exposing Unit
(Model E1-4731 only)
2)
Place Legs on a clear spot on the floor,
28.5” (72.5cm) apart as shown in picture 1a.
3)
Lock lid handles as shown. Carefully lower
the exposing unit down onto the legs. Two
people are required to do this as caution
must be taken to not damage the machine’s
glass or rubber blanket.
4)
Legs are installed with (8) 3/8" bolts, (16) 3/8”
washers and (8) 3/8” nuts. Use (2) 9/16”
open end wrenches and tighten all bolts well.
Assembly Cont’d
Steps 1 & 2
Step 3
Step 4
Step 5
Pg. 5
