This model also incorporates an internal fan, which can be switched on independently of the
heating elements.
Fan Operation: -This is operated by means of the switch with the fan symbol along side it. The fan
will only operate with the thermostat in the “on” position and can be used when the heating
elements are “on” to blow warm air into the room. In warm conditions the fan can be used with
the heating elements “off” to blow cool air into the room.
CLEANING THE HEATER
Always un-plug the heater from the wall socket and allow it to cool down before cleaning.
Clean the outside of the heater by wiping with a damp cloth and buff with a dry cloth.
Do not use any detergents or abrasives and do not allow any water to enter the heater.
STORING THE HEATER
When the heater is not used for long periods of time it should be protected from dust and stored in
a clean dry place.
WALL- MOUNTING THE HEATER
Caution: - there should be a distance of at least 40 cm between the lower part of the appliance and
the floor.
- the feet must be removed before mounting the appliance on the wall
1.
Measure the distance between the two slots situated at the back of the appliance (see picture A)
2.
Drill two holes at the same distance in the wall and insert a plug in each hole you just drilled.
Place the brackets facing the holes as indicated on picture B and attach them in this position
with the screws supplied.
3.
Before attaching the appliance on the brackets, attach the two other brackets underneath the
appliance as indicated on picture C.
4.
Attach the appliance on the wall. To do so, hold it in such way that the slots are facing the
brackets; insert the appliance halfway onto the brackets until the appliance can go down into
the grooves of the brackets.
5.
As soon as the appliance is positioned correctly, take a pencil and mark a dot in the hole of each
bracket situated underneath the appliance.
6.
Then take off the appliance by proceeding the other way around compared to point 4 above.
7.
Drill a hole in the wall on each dot you just marked and insert a plug in each hole.
8.
Attach the appliance back on the wall as indicated in point 4, insert screws through the brackets
underneath the appliance and tighten without forcing.
