Model # XL50-6GB
Please call for replacement parts or assistance:
1-866-942-5362
VAS Furniture Mfg. Inc.
Factory No. 56-12089
Page 10
Assembly Instructions for Universal Wall Mount
Installing XYZ Mounting Frame onto WOODEN WALL
14. The XYZ Mounting Frame (J) mus
t be mounted to two Wood Studs at least 12” apart, using a
high quality Stud Finder to locate the two adjacent studs. After you have located the studs,
verify with a nail for added security. See detail #6A.
15. Pre-drill a 2 1/2" deep hole at the desired heigh
t in each stud using a 3/16” drill bit, make sure
that the holes are centered in the studs and level with each other. Use the XYZ Mounting
Frame (J) as a template to mark the corresponding location for the bottom holes in each stud,
drill holes 2 1/2" deep
with the 3/16” drill bit at the marked location.
16. Orient the Mounting Frame with the
“C” rail against the wall, and using four Lag Bolts (7) with
Large Flat Washer (8) through the
slots of “C” rail on Mounting Frame into the holes in the
wall, secure the mounting frame to the wall as shown in detail #6B.
Hardware provided
Sketch
Qty.
(7)
–2 1/2” Lag Bolt
(4)
(8)
– Large Flat Washer
(4)
Tools required
Stud Sensor, Mallet, Power Drill, 3/16” Drill Bit, Socket Set
Do not over tighten the Lag Bolts. Tighten Lag Bolts only until the Lag
Bolt Washer is pulled firmly against the
“C” Plate of Mounting Frame. If there is a layer of
drywall or other material, this drywall or other material may not exceed 5/8 inch in
thickness. Failure to heed this caution may result property damage and/or personal injury.
