Model # XL50-4MC
Please call for replacement parts or assistance:
1-866-942-5362
VAS Furniture Mfg. Inc.
Page 17
Factory No. 56-12089
Assembly Instructions for Universal Wall Mount
Installing XYZ Mounting Frame onto WOODEN STUD WALL
26. The XYZ Mounting Frame (O)
must be mounted to two Wood Studs at least 12” apart, using
a high quality Stud Finder to locate the two adjacent studs. After you have located the studs,
verify with a nail for added security. See detail #13A.
27. Pre-
drill a 2 1/2" deep hole at the desired height in each stud using a 3/16” drill bit, make
sure that the holes are centered in the studs and level with each other. Use the XYZ
Mounting Frame (O) as a template to mark the corresponding location for the bottom holes
in each stud,
drill holes 2 1/2" deep with the 3/16” drill bit at the marked location.
28. Orient the Mounting Frame with the
“C” plate against the wall, and using four Lag Bolts (8)
with Large Flat Washer (7) through the
slots of “C” Plate on Mounting Frame into the holes
in the wall, secure the mounting frame to the wall as shown in detail #13B.
Do not over tighten the Lag Bolts. Tighten Lag Bolts only until the Lag
Bolt Washer is pulled firmly against the
“C” Plate of Mounting Frame. If there is a layer of
drywall or other material, this drywall or other material may not exceed 5/8 inch in
thickness. Failure to heed this caution may result property damage and/or personal injury.
The following steps are only for those who wish to mount their
TV directly to the wall. If you have already mounted your TV to
the Swinging Floater or plan to display your TV on the top
surface of the stand, disregard the following steps.
Hardware provided
Sketch
Qty.
(7) Large Flat Washer
(4)
(8) 2-
1/2” Lag Bolt
(4)
Tools required
Stud Sensor, Mallet, Power Drill, 3/16” Drill Bit, Socket Set
