Varytec LED Spot 3, User Manual

Page: 4 / 6

4 / 6
Important: Damages caused by the disregard of this user manual are not subject to
warranty. The dealer will not accept liability for any resulting defects or
problems. Make sure the electrical connection is carried out by qualified
personnel. All electrical and mechanical connections have to be carried out
according to the European safety standards.
2. Features
- Multicolour
- Electronic dimming device 0 – 100%
- Built in microphone
- DMX 512 Protocol
- 3 or 5 DMX Channels
- Master Slave Mode
2.1. Powerconnection
Before connecting this item to the mains make sure that the local power connection is fitting to this
LED Spot 3! The LED Spot 3 needs 100V ~ 230V AC.
3. Working Modes
3.1. Music control mode
In this mode the LED Spot 3 react to music and plays the different colors.
1. Power on the item and set the Dip switch #10 to ON
2. Now the item changes the color according to the music.
3.2. Master Slave mode
With this function you can connect up to 16 fixtures and use them without a controller. The items work
in a music control mode. In this mode one item works as control unit and the ithers reacting according
to it and its preprogrammed programs. Each item can be defined to be a master or a slave.
1. Daisy chain the items with DMX Cables using the backside XLR Connectors.note that the
male connector is the IN and the female connector is the out at the item. The first item in the
row uses the female connector only and the last item in line should use the male connector
only. If the cable are longer then you should use a terminator at the end of the line.
2. At the master item you should set up the dip switches 1-9 to OFF
3. At the slave unit please set all dip switches to ON
4. Now the slave items follow the master and its programs.
3.3. 4-Light show (in Master Slave Mode)
With this function you can set up a 4-light show from the master or from a slave item. Please do
step 1 from setting up a master slave mode and then go a s described here: