Varytec LED Pad Bar Compact ST RGB, User Manual

Page: 34 / 56

This setting is only relevant if the device is working as Slave in a Master / Slave configuration
and is not controlled via DMX.
Press
[MENU] repeatedly until the display shows ‘SLA’ . Use [UP] or [DOWN] to select the option
‘S001’ to enable the Slave mode.
Confirm with [ENTER] . Now you can set the Salve address. Use [UP] and [DOWN] to select a
value between ‘001’ … ‘512’ and confirm with [ENTER] .
To activate the ‘Master’ mode in synchronous mode, proceed as follows:
Press
[MENU] repeatedly until the display shows ‘SYS’ . Use [UP] or [DOWN] to select the option
‘M-En’ and confirm with [ENTER] . Use [UP] or [DOWN] to select the option ‘On’ to enable the
operation mode. Confirm again with [ENTER] to apply the setting.
To initiate the self-test function, proceed as follows:
Press
[MENU] repeatedly until the display shows ‘SYN’ . Use [UP] or [DOWN] to select the option
‘tESt’ and confirm with [ENTER] to initiate a self-test.
Operating mode ‘Slave’
Operating mode ‘Master’
Self test
Operating
LED lighting set
34