Varytec Laser Moonstar MK II, User Manual

Page: 8 / 22

8 / 22
4. GENERAL SAFETY INSTRUCTIONS
Every person involved with installation and maintenance of this device has to
Be qualified.
Follow the instructions of this manual.
CAUTION! Be careful with your operations. With a high voltage you can suffer a dangerous electric shock
when touching the wires!
This device has left out premises in absolutely perfect condition. In order to maintain this condition and to ensure
a safe operation, it is necessary for the user to follow the safety instructions and warning notes written in this
manual.
Important!
The manufacturer will not accept liability for any resulting damage caused by the non-
observance of this manual or any unauthorized modification to the device.
- Please consider that damages caused by manual modifications to the devise are not subject
to warranty.
- Never let the power-cord come into contact with other cables! Handle the power-cord and all
connections with the mains with particular caution!
- Make sure that the available voltage is not higher than stated on the rear panel.
- Always plug in the power plug least. Make sure that the power-switch is set to off-position
before you connect the device to the mains. The power-plug has to be accessed after
installing the device.
- Make sure that the power-cord is never crimped or damaged by sharp edges. Check the
device and the power-cord from time to time.
- Always disconnect from the mains, when the devise is not in use or before cleaning it. Only
handle the power-cord by the plug. Never pull out the plug by tugging the power-cord.
- It is essential to connect the yellow/green conductor to earth.
- The electric connection, repairs and servicing must be carried out by a qualified employee.
- Do not switch the fixture on and off in short intervals as this would reduce the laser diode life.
- For replacement, please use fuses of same type and rating only.
- If the device has been exposed to drastic temperature fluctuation, do not switch it on
immediately. The arising condensation water might damage your device. Leave the device
switched off until it has reached room temperature.
- Do not shake the device. Avoid brute force when installing or operating the device.
- When choosing the installation-spot, please make sure that the device is not exposed to
extreme heat, moisture or dust. There should not be any cables lying around. You endanger
your own and the safety of others!
- The minimum distance between the fixture and surrounding walls must be more than 50cm.
- Always fix the fixture with an appropriate safety-rope. Fix the safety-rope at the safety-rope
only.
- The ambient temperature must be between 10
℃
to 40
℃
.