14” Fast Scan Series User Guide 150-049
-1-
The following warnings and cautions are for your safety, for the prevention of injury from electric
shock and for the safe operation of the monitor. Please read them carefully.
♦
Do not block the ventilation slots or insert any objects into the monitor through them.
♦
Do not spill water onto the monitor or spray aerosol cleaners directly onto its surfaces when
cleaning.
♦
Always position and operate the monitor on a stable and safe surface.
♦
Do not install the monitor in a damp area, or where it may be exposed to rain or other sources of
water.
♦
Ensure that all accessible cables cannot be walked on, tripped over or damaged by furniture or
other transportable objects.
♦
If the monitor is damaged or fails to function correctly, disconnect it from the AC source. Do not
attempt to repair it yourself. Consult a qualified service technician.
♦
Serious electrical shock hazards exist within the covers of the monitor. Under no circumstances
should these covers be removed.
WARNING
Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
NOTE
This equipment has been tested and found to comply with the limits for a class B digital device,
pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference using one or more of the following
measures:
- Reorient or relocate the receiving antenna;
- Increase the separation between the equipment and the receiver;
- Connect the equipment into an outlet on a circuit different from that to
which the receiver is needed;
- Consult the dealer or an experienced radio/TV technician for help.
SAFETY WARNINGS
SAFETY WARNINGS
1
Section