3
Installation:
Do not install camera by yourself. Let qualified personnel from service center do that.
Please read the following instructions and choose the installation method that best suits your vehicle
and product type purchased.
A: Attach the camera below the trunk lid, usually above the license plate. Use the loosening-proof
nuts attached inside the box to prevent from theft. Cable can entry through the hole of license-plate's
light. It is highly recommended to install the camera under the trunk lid from inside out. To do this,
uninstall the trunk lid first, drill a hole on it with an approximate diameter of 20 mm, and then fix the
camera from inside out. You can use the holes provided in your car.
B: You may use the screws or double-adhesive tape to fix the camera. You may need to fold the
bracket properly if the camera is installed inside the vehicle. You can use the holes provided in
bumper of your car.
C: If you purchased the hole mount type camera, drill a hole on the rear bumper with a diameter of
23 or 26 mm (Please choose a size that applies), then insert the camera temporarily. Do not tighten
the nut until the right display has been adjusted.
D: If you purchased the side view camera type, make sure the position of the camera has been
adjusted appropriately and the bracket have been folded to fit the curvature of the front bumper.
Then drill the holes on the bumper and fix the camera.
E: If you purchased the forward view camera type (same type as under option D), you may install
the camera with screws or double-adhesive tape after the correct display has been adjusted. It is
recommended to attach the camera at the top of the windshield inside the vehicle.
