5
.
The product is turned on and enters the power-on state, and immediately starts
pulse oxygen supply. There are four timing time periods to choose from, 40 minutes,
60 minutes, 80 minutes and 180 minutes, and it will automatically shut down when it
is used.
The
use of nasal oxygen inhaler
1. Connect one end of the oxygen inhalation tube to the nasal inhaler and the other
end to the oxygen output port of the device.
2. When using the oxygen inhaler, the tube must be connected correctly and not
folded, so as not to inhale oxygen normally;
3. See the following
Specific operation
1. Take out the oxygen generator and insert the output plug of the power supply or
battery pack into the power socket of the oxygen generator. If it is from a low
temperature environment to a room temperature environment, it needs to be placed
for 4 hours before performing this operation, such as from outdoors-100C gets
indoor 200C, it needs to be placed for 4 hours before use.
2. Standard battery pack
3. Take out the nasal suction tube and insert the air inlet of the nasal suction tube
into the air outlet of the oxygen generator;
4
.
Put
on
the
nasal
straw
,
as
shown
in
the
picture
below
5.Press the power switch button of the oxygen generator, you will hear a beep, and
the machine starts to work;
6
.
If you need to adjust the different use time, press the green SET button and
follow the instructions to set: 40 minutes, 60 minutes, 80 minutes, 180 minutes, a
total of 4 time levels
；
The timing setting button only works when the machine
is turned on, and it cannot be used after the machine is
turned off.
On the left is the charger socket. The rubber cap
should be fastened when not in use to prevent short
circuit damage to the battery or accidents.
The one on the right is the output line, which can be
plugged into the power socket of the oxygen
generator to supply power to the oxygen generator.
The upper one is the air outlet connector, the lower one
is the power socket, which can be connected to a
battery pack or a power adapter
Turn on or turn off the button; in the off state, click
to turn on, and in the on state, click to
- 4 -
- 5 -
