POWXQG7571
EN
Copyright © 2014 VARO
P a g e
|
7
www.varo.com
8.3
Adjusting the cutting height (5)
Before adjusting the cutting height, switch off the engine. Let the cutting blade come to a
complete standstill before making any adjustment of the cutting height. Adjustment can be
done either to the "+" or to the "-" direction. Adjustment takes place in steps. Make sure that
the adjustment lever securely snaps in at the desired height position.
9
OPERATION
9.1
Read the engine manual before using the lawn mower.
The lawn mower is delivered without engine oil: Add 0.6 litres of engine oil, before starting the
engine.
9.2
Starting the engine
After proper assembly of the lawn mower, start the engine as follows:
Put the lever on START or
.
Pull the engine control lever (3) towards the handle. Pull the recoil starter, until resistance
is felt, and then pull it firmly.
When the engine runs, put the throttle (2) to the "RUN" position.
The blade starts to rotate after start-up of the engine. Keep the engine
control lever (3) in working position during operation of the lawn mower.
The engine will stop as soon as you release the engine control lever.
9.3
Self-propelling function
To activate the self-propelling function press the self-propelling lever (1) towards the handle.
WARNING: The lawn mower immediately starts moving. To stop the
movement, release the self propelling lever (1). The lawn mower will then
stop immediately.
9.4
Protective cover of the driving belt (Fig 3)
Do not try to open the protecting cover of the driving belt.
If the protecting cover of the driving belt is damaged, it must be replaced by the manufacturer,
your dealer or a person with a similar qualification.
10 4 IN 1
These lawn mowers can be retrofitted from its normal function, based on the application
purpose:
From lawn mower with rear discharge to:
Mulching mower or as side-discharge mower.
10.1
What is mulching
When mulching, the grass is cut in one working step, then finely chopped and returned to the
grass strip as natural fertilizer.
Hints for mulch-mowing:
Regular cut-back by max.2cm from 6cm to 4cm grass height.
Use a sharp cutting knife
Do not mow wet grass
Set to max. motor speed
Only move at working pace
Regularly clean mulching wedge, housing inner side and mowing blade
