POWC1030
EN
Copyright © 2019 VARO NV
P a g e
|
7
www.varo.com
9 LUBRICATION - OIL LEVEL
Check the oil level before using the machine.
The oil should be changed after around 40-50 hours of use.
Recommended oil: 25ml SAE 15W/40 or an alternative of the same quality.
9.1
Oil change
▪
Before feeding oil, use the provided wrench to remove the oil gauge (4). Be careful not to
lose the rubber packing attached below the oil gauge.
▪
Check the oil level once daily, confirming that oil us filled.
▪
After feeding oil, securely clamp the oil gauge
Important: The waste oil must be disposed of in the appropriate collection
point for waste oil.
10 CLEANING AND MAINTENANCE
Attention !Before performing any work on the equipment, pull the power
plug.
10.1
Cleaning
▪
Keep the ventilation slots of the machine clean to prevent overheating of the engine.
▪
Regularly clean the machine housing with a soft cloth, preferably after each use.
▪
Keep the ventilation slots free from dust and dirt.
▪
If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.
11 TECHNICAL DATA
Rated Voltage
230 V
Rated Frequency
50 Hz
Rated Power
900W
Rotation speed
800min
-1
Protection class
II
Drill capacity concrete
26mm
Drill capacity steel
13 mm
Drill capacity wood
40mm
Impact rate
4000 min
-1
Cable length
2m
