POW30001
EN
Copyright © 2011
P a g e
|
6
8 OPERATION
8.1
Selecting the operation mode
Select the required operating mode before use (drilling or hammer drilling).
§
For drilling in wood, metal, plastics and soft stone, push the switch (3) to the drill position.
§
For drilling in concrete or hard stone, push the switch (3) to the hammer position.
8.2
Forward / reverse lever
§
To select forward position (right rotation), push the forward / reverse lever to the right (R).
§
To select the reverse position (left rotation), push the forward / reverse lever to the left (L).
8.3
Variable speed
This tool has a speed control dial (6) that delivers higher speed by turning to the “+” position
and delivers lower speed by turning to the “-“ position.
8.4
Switching ON and OFF
Connect the tool to the power supply.
To start the machine, you squeeze the ON / OFF switch (4).
To stop the machine, you release the ON / OFF switch.
8.5
Continuous mode
To switch the machine to continuous mode, keep the on/off switch pressed and at the same
time press the lock-on button (5). Subsequently release the on/off switch.
To switch off continuous mode, press the on/off switch again.
Never put down the machine when using the continuous mode!
9 CLEANING AND MAINTENANCE
Before performing any work on the equipment, pull the power plug.
9.1
Cleaning
§
Keep the ventilation slots of the machine clean to prevent overheating of the engine.
§
Regularly clean the machine housing with a soft cloth, preferably after each use.
§
Keep the ventilation slots free from dust and dirt.
§
If the dirt does not come off use a soft cloth moistened with soapy water.
§
Never use solvents such as petrol, alcohol, ammonia water, etc. These solvents may
damage the plastic parts.
9.2
Replacing coal brushes
Remove and check the carbon brushes regularly. Replace when they have worn down to the
limit mark. Keep the carbon brushes clean and free to slip in the holders. Both carbon
brushes must be replaced at the same time. Only use original carbon brushes.
9.3
Maintenance
Our machines have been designed to operate over a long period of time with a minimum of
maintenance. Continuous satisfactory operation depends upon proper machine care and
regular cleaning.
