POWXG90410
EN
Copyright © 2018 VARO
P a g e
|
6
www.varo.com
WARNING: High pressure jets can be dangerous if subject to misuse. The
jet must not be directed at persons, live electrical equipment or the
appliance itself.
WARNING: Do not use the appliance within range of persons unless they
wear protective clothing.
▪
Do not direct the jet against yourself or others in order to clean clothes or foot-wear.
▪
Hold the spray lance firmly with both hands.
▪
The operator and anyone in the immediate vicinity of the site of cleaning should take
action to protect them from being struck by debris dislodged during operation.
▪
Wear goggles and protection clothes during operation.
▪
Disconnect from electrical power supply before carrying out user maintenance.
▪
To ensure appliance safety, use only original spare parts from the manufacturer or
approved by the manufacturer.
▪
Do not use the appliance if a supply cord or important parts of appliance are damaged,
e.g. safety device, high pressure hose and trigger gun.
▪
Do not use the appliance with wet hands. If the appliance is humid or wet, unplug it
immediately. Do not put it in water.
▪
Tires and tire valves may be damaged by the high-pressure jet and then burst.
▪
Never use the machine in an environment where there could be a danger of explosion.
▪
It is not allowed to clean asbestos- containing surfaces with high pressure.
▪
This high pressure washer must not be used at temperatures below 0°C
WARNING: High pressure hoses, fittings and couplings are important for
the safety of the appliance. Use only hoses, fittings and couplings
recommended by the manufacturer.
WARNING: Inadequate extension cables can be dangerous. Cables on reels
should always be completely unwinded to prevent the cable from
overheating.
▪
If an extension cable is used, the plug and the socket must be waterproof and comply with
the below-mentioned requirements for length and cable dimensions.
−
1.0 mm² max. 12.5 m
−
1.5 mm² max. 20 m
▪
If the electric cable is damaged, it must be replaced by the manufacturer or his service
agent or similarly qualified person in order to avoid a hazard.
6.1
Mains power connection
The following should be observed when connecting the high pressure washer to the electric
installation:
▪
The electric supply connection shall be made by a qualified electrician and comply with
IEC 60364-1
▪
It is recommended that the electric supply to this appliance should include either a residual
current device that will interrupt the supply if the leakage current to earth exceeds 30 mA
for 30 ms.
6.2
Water connection
▪
Connection to the public mains according to regulations.
▪
Inlet hose can be connected to the water mains with a max. inlet pressure of 12 bars.
