POWXG60210
EN
Copyright © 2015 VARO
P a g e
|
9
www.varo.com
CAUTION: Wipe off any spilled oil or fuel. Do not store, spill or use gasoline
near an open flame
CAUTION: Alcohol blended fuels (called gasohol or using ethanol or
methan can attract moisture which leads to separation and formation of
acids during storage. Acidic gas can damage the fuel system of an engine
while in storage. To avoid engine problems, the fuel system should be
emptied before storage (See chapter Storage, further in this manual)
9.2
Starting the engine
To start the engine, first make sure that the spark plug cap is connected and that the machine
is filled with sufficient oil and gasoline.
NOTE: Due to protective coatings on the engine, a small amount of smoke
may be present during the initial use of the product and should be
considered normal.
Push 3 times the primer bulb. Hold operator presence control bar down Pull the brake lever to
the handle and pull starter handle quickly. Do not allow starter rope to snap back.
NOTE: In cooler weather it may be necessary to repeat priming steps.
9.3
Stop engine
To stop engine, release the brake lever.
WARNING ! The blade will continue to rotate for a few seconds after the
engine has stopped. Disconnect the spark plug cap if the lawnmower is to
be left unattended.
9.4
Self-propelling function
Self-propelling is controlled by holding the brake lever up to the handle and pushing the
drive control lever forward until it clicks.
Forward motion will stop when drive lever is released. To stop forward motion without
stopping engine, release the drive lever slightly until the drive control disengages. Hold
brake lever up against handle to continue mowing without self-propelling.
WARNING: The lawn mower immediately starts moving. To stop the
movement, release the brake lever (1). The lawn mower will then stop
immediately.
9.5
Height adjustment instructions
Caution: before changing mowing height, stop mower and disconnect spark
plug cable.
Your mower is equipped with a central height adjustment lever offering 6 height positions.
Stop mower and disconnect spark plug cable before changing mower cutting height.
To change the height of cut, squeeze adjuster lever toward the wheel, moving up or down
to selected height.
