3
Connecting the Cables
1.
Connect the locking 4-pin control cable to the 4-pin motor cord at the
base of the MC100.
2.
Connect the other end of the 4-pin control cable to the
MC100 Control Unit at the locking 4-pin connector.
The additional 3-pin port located beneath the motor cable port
will provide 24VDC output.
3.
Connect the 4-pin XLR power cable from the AC adapter to the
4-pin XLR power connector located on the MC100 Control Unit.
OPERATION OF MC100 CONTROL UNIT
1.
The joystick controls the head in an intuitive manner. You can change the
direction of the pan response by flipping the switch “L” to “R”, while the
middle position of the switch “OFF” will put the motor into neutral. This
OFF position is very helpful in situations where you want to prevent motion
or to pan without tilting (or vice-versa). You can also change the direction
of the tilt response by flipping the switch “Up” to “Dn”, while the middle
position of the switch “OFF” will put the motor into neutral.
Also note the silver dials for changing the maximum pan and tilt speeds.
You may want to keep these turned up at least 1/3 of the way for best
operation.
Overslung/Underslung Operation
When switching between overslung and underslung, the left-right (pan)
response of the joystick will be flipped. The toggle switch on the control box
allows you to reverse the left-right response of the joystick.
