3-16
VariQuest
®
Perfecta™ 3600STP
User’s Guide
Change Cutter Settings
Use Form Feed With or Without Cutting
Use Form Feed With or Without Cutting
There are at least two reasons why you might want to advance the form feed with
or without cutting:
•
To trim the leading edge of the paper if it is damaged or not straight.
•
To feed and cut the paper when the automatic cutter has been disabled.
To advance form feed:
1. Swipe down the dashboard and from the front panel, touch
. Choose one
of the following:
-
Touch
Form feed
. The printer advances.
-
Touch
Form feed and cut
. The printer advances the paper and makes a
straight cut across the front edge.
Note:
The printhead is serviced after each print, and the paper cannot be cut
until the process completes, so you may notice a delay.
CAUTION!
CAUTION!
Remove the cut piece from the output platen. If strips or short prints are left on the
output platen, the printer could jam. Check also that there are no pieces of paper
in the cutter guide.
Note:
Photo and coated paper requires careful handling, see
Paper or Paper Quality Issues” on page 6-6
2. To advance the paper without cutting it, swipe down on the dashboard, touch
, then touch
Form Feed
.
