Varioprop Uno S2R, Instruction Manual, Page: 7 / 10

The EPA supports precise and individual endpoint adjustment in each direction for the steering and throttle channels.
1. Hold the throttle trigger in the full brake position while powering on the transmitter
2. The red LED flashes rapidly, indicating the programming mode is active.
3. Throttle End Point adjustment: Hold the trigger in the full throttle position and increase or reduce the travel with the TH
Trim button.
4. Brake End Point adjustment: Hold the trigger in the full brake position and increase or reduce the travel with the TH Trim
button.
5. Left Steering End Point adjustment: Hold the steering wheel in the full left position and increase or reduce the travel
with the ST Trim button.
6. Right Steering End Point adjustment: Hold the steering wheel in the full right position and increase or reduce the travel
with the ST Trim button.
7. Power Off the transmitter to save the new EPA settings.
Please note! The transmitter stops the linking procedure after the third double beep signal.
1. Gently pull the trigger to move your model forward.
The speed is proportional, the more you pull the trigger, the faster the model moves forward.
2. Release the trigger in neutral position to slow down your model.
3. Pull the trigger forward to brake your model.
For reverse, after stopping the model, release the trigger to neutral position then pull the trigger forward again to
activate reverse.
Gently rotate the steering wheel clockwise/counter-clockwise to turn the
wheels. The steering is proportional, the more you turn the wheel, the more the
wheels will turn.
NEUTRAL FULL THROTTLE
STEERING WHEEL
DRIVE YOUR MODEL
MOVE YOUR MODEL
BRAKE/REVERSE
7
CHANGING THE TRAVEL ADJUST SETTINGS (EPA)
OPERATE YOUR MODEL