18
INSTALL SPECIAL V-BELT (A).
19
INSTALL FORK ASSEMBLY (X).
20
INSTALL WASHERS (G) (H) AND NUT (J).DO NOT TIGHTEN NUT.
21
START THE MIXER AND TIGHTEN THE NUT (J).
DO NOT OVERTIGHTEN!
22
ON THE FRONT PULLEY SET,THE STUD (K) ON THE VARISPEED COLLAR (L) MUST BE PLACED
INSIDE THE LOWER FORK (M),AND ON THE REAR PULLEY SET OUTSIDE THE FORK (N).
23
ADJUST THE SPEED BY TURNING THE THE STOP SCREWS (O) IN OR OUT.
24
THE STOP SCREWS (O) ON THE SPEED LEVER SHOULD BE ADJUSTED SO THAT THE
MEASUREMENT (P) IS 1-2MM ON THE FRONT AND REAR PULLEY,AT HIGH AND LOW SPEED,
RESPECTIVELY.TIGHTEN THE JAM NUTS (R) WHEN THE SPEED IS CORRECTLY ADJUSTED.
Motor Removal Instructions
Models W30-W150
