Varimixer V80, Spare Part And Operation Manual

Page: 6 / 40

6
Emergency stop
Fig. 3
Mixer seen from above
,
the bowl has been pushed
all the way into the bowl
arms. Notice: the centre
“ear” of the bowl is fac-
ing the mixer
Fig. 2
Speed selector and
manual Bowl lift.
First “ear”
Second “ear”
Centre
“ear”
Fig. 1 Operation panel.
Timer/
Display
Start/Stop
Time up
Time
down
Speed selector lever
Low
speed
High
speed
Before the mixer is stopped, lowest
speed must be selected.
Pause
(power lift only)
Bowl down
(power lift only)
Bowl up
(power lift
only)
Operation of the mixer:
A) Place the tool in the bowl. Open the bowl screen
B) Note: the bowl arms must be in the lowest position . Place
the bowl in the bowl arms. Check that the bowl is pushed right
back into the arms and that the “centre ear” of the bowl arms
is facing the mixer (fig. 3) . Place the mixer tool in the bayonet
shaft. The tap of the tool must be turned right into the bayo-
net hole. Close the bowl screen.
C) Raise the bowl to working position by turning the handle for
bowl lift towards your selves (fig. 2) (manual bowl lift) or by
pressing (fig. 1) (Power lift). The bowl will automatically
stop in the top position.
D)
The mixing time can be set on the timer using the and
buttons. The mixer stops automatically when the mixing
time has run out. (If the mixer stops at high speed when the
mixing time runs out, follow the instructions “Start-up after
stop at high speed” before starting the mixer again).
You can also start the mixer without setting a time. If you do
not set a time, the display will function as a clock that counts
up. See also “Timer function” on page 7
E) Start the mixer by pressing (fig.1)
F) Turn the speed selector lever (fig. 2) to the rear until the
required speed has been obtained, (notice the recommended
maximum speeds on page 9).
The speed must be changed only when the mixer
is running.
The mixer must not be started in high speed
when loaded.
Always change to low speed before stopping the
mixer
G) Only for power Lift!
During the mixing process the mixer can be paused by pressing
( first change to low speed ). You can now lower the bowl
or open the bowl screen. If you start the mixer again using
the timer settings will be unchanged.
H) Before the mixer is stopped, the speed selector lever must
be moved back to lowest speed (fig.2) . Stop the mixer by
pressing (fig.1).
J) When the tool has stopped rotating the bowl can be lowered
by pressing (power lift) or by turning lever for bowl lift to
the rear.
Pause function (Power Lift):
The mixer has a pause button , which should be used to stop
and start the mixer in a process where the timer is used.
• Change to low speed
• Stop the mixer using . The timer will continue to count
downwards when you start the mixer again by pressing .
• When you stop the mixer pressing you can lower the
bowl and open the bowl screen. When you press again,
the timer continues to count downwards.
• If you start the mixer using the settings will be reset. See
also “Pause function”
Lever for
manual
bowl lift