Varimixer AR30 VL-1S, Operating Instructions Manual

Page: 7 / 20

7
Emergency stop
Only to be used for
emergency situations
and for powering off
the mixer
Timer [mmss]
Reset the timer by pres -
sing the two timer but -
tons at the same time.
Time is shown in mi-
nutes and seconds.
Time down
Time up
Power off the mixer
-
Push the emergency stop
Power on the mixer
-
Turn the emergency stop clockwise
Bowl down/
Speed down
Bowl up/
Speed up
Start/Stop
Pause
To be used when check -
ing the contents of the
bowl or otherwise pau -
sing the mixer
Before starting the mixer:
Ingredients can be filled in the bowl at any time before
the mixer is started.
1. Place the tool in the bowl.
2. Place the bowl in the bowl arms.
3. Fit the rear part of the safety guard.
4.
Grab the tool and lock it into the bayonet fitting.
5. Lift the bowl to working position.
6. Fit the front part of the safety guard
If desired, set an operating time.
The mixer is now ready to be started.
Start the mixer:
Press to start the mixer.
Set the speed, press or speed indicator on the
right side of the mixer (notice the recommended maximum
speeds on page 6).
The mixer will run until the time set on the timer runs out or
the user stops the mixer.
Pause the mixer without resetting the timer
If it is needed to ad ingredients or check the content of the
bowl, the mixer can be stopped without resetting the timer.
• Press the mixer stops
Safety guard can now be opened and the bowl can be
lowered.
To start the mixer again, close the safety guard and/or
lift the bowl. The mixer can now be started by pressing
the timer will continue counting down.
Reset the timer:
Reset the timer by pressing the two timer buttons at the
same time.
Use emergency stop for stopping the mixer:
The emergency stop should only be used in
emergency situations and for powering off the
mixer. Not used in normal operation.
If the emergency stop is activated or main power to the
mixer is cut off, the tool stops rotating and the timer is
reset to zero.
Timer automatically repeats the previous setting:
When the running time runs out, the tool stops rotating,
the timer shortly display [0000] and will then display the
previous selected running time.
More about the timer:
Timer settings of up to 90 minutes
If no running time is selected, the display will show the
time elapsed since the mixer was started.
Automatic lowering of the bowl:
If the timer is in use, the bowl can automatically be low-
ered when the time runs out and the mixer stops.
While the mixer is running, briefly press , The green
LED by will flash until the mixer stops.
When automatic lowering of the bowl is selected it is
important that you use
to stop and start the mixer,
otherwise the selection will be reset.