8
fig.5
Prior to repair or adjustment, switch off the mixer by disconnecting the power cable.
Maintenance and lubrication:
The infinitely variable gear must be lubricated regularly,
i.e. a lubrication interval of approx.
60 hours
of operation.
Fig 5, Lubrication of infinitely variable gear
and other
movable parts:
OBS
. Special grease !!(Use the grease gun delivered
together with the mixer). Start the mixer and increase the
speed to approx. 50%. Stop the mixer (use the emergency
stop) and open the lid on the top of the mixer. On the top
of each of the two pulley set shafts is a grease nipple
(fig.
5 point 1)
. Press grease through the grease nipples
until the grease gun feels hard to press or until grease
comes out between the shaft and the pulleys.
The mixer must not be started until the screws
which hold the lid are inserted.
Start the mixer, and set the speed back to low speed.
Stop the mixer and fill the grease gun with new grease
so that it is ready for next time.
Lubrication of other movable parts:
The movable parts of the bowl arms, the shaft and the
lifting rod must also be lubricated with oil. Remove the
rear covering and lubricate the marked points with an oil
can.
(fig.5 pkt.2)
Safety switch for
safety guard
Safety switch
for bowl lift
Motor
Construction of the mixer:
fig.5
Speed adjustment
Lift/lowering of bowl
Motor relay /
thermal over-
load relay
Electrical Fuse
Safety switch
for bowl lift
Motor
Construction of the mixer:
